D-Link DVG-2101S - Manual (Page 20)

DVG-2101S User Manual
Setup
18
VoIP Setup
The VoIP (Voice over Internet Protocol) Adapter can be configured to handle
voice communication over the Internet. The screen shown below, along with the
SIP account list and phone book pages are used to configure the basic settings
to allow you to communicate with the devices that will send and receive
telephone calls over the Internet.
SIP Account List
The VoIP Adapter allows you to make calls through the Internet or PSTN. You
need to configure the SIP account before you can make a VoIP phone call.
Display Name Enter your display name. Every outgoing call will carry this
name to the receiver and it should appear on the Caller-ID.
User Name Enter your SIP account username. The username is the part
that comes before the “@” symbol. A username can be letters
like in an e-mail address (e.g. [email protected]) or
numbers like a telephone number (e.g. [email protected]).
Authorization
Name Enter the authorization name to authenticate your SIP account.
This is usually the same to your SIP account’s user name.
Password Enter the password to authenticate your SIP account.
Proxy Server Enter the SIP proxy server’s IP address and port number in this
field (e.g. 192.168.0.253:5060).
Outbound
Proxy Server Enter the outbound proxy server IP address and port number in
this field (e.g. 192.168.0.1:5060).
Expire Time Enter the amount of time for the dial tone when the phone has
been lifted off the hook. At the end of this time period, if no
numbers have been dialed, the device will start playing the
busy tone.
MWI Check the checkbox to activate MWI (Message Waiting
Indication) if the SIP server supports this service.