Thor 1- 4 HDMI to QAM Modulators - Manual (Page 4)

H-4SDI-or-4HDMI-QAM-IP
Chapter 1 Introduction
1.1 Product Overview
H-4SDI-(HDMI)-QAM-IP series products are Thor’s new breakthrough all-in-one
devices which integrate encoding (MPEG-2 HD/SD, MPEG-4/AVC H.264 HD/SD)
and modulating to convert V/A signals into DVB-C RF output. It is equipped with 4
SDI, or HDMI) channel input and 1 ASI input and output with 2 ASI ports and 1 UDP
IP port. Delay problems have been greatly reduced to achieve an extremely low
value from the encoding progress to the decoding terminals. It adopts inner
drawer-type structural design which greatly facilitates the change of encoding
modules (HDMI/SDI /…) as needed. The signal source could be from satellite
receivers, closed-circuit television cameras, Blue-ray players, and antenna etc. Its ’
output signals are to be received by DVB-C TVs or STBs and etc.
1.2 Key Features
 MPEG2 & MPEG4 AVC/H.264 HD/SD encoding
 Up to 1920*1080@50P/60P supported (MPEG4 AVC/H.264 HD)
 Up to 1920*1080@50I/60I supported (MPEG2 HD)
 4* SDI(HDMI) input; 1*ASI input for re-mux; 1*RF input for mix
 4* DVB-C RF out (4 carriers combined output)
 Support 4 * SPTS output
 Extremely low delay
 LCN support (Logical Channel Number)
 Excellent modulation quality MER≥42dB
 RF Frequency range 30Mhz~960Mhz
 LCD display, Remote control and firmware
 Web NMS management; Updates via web
 Lowest cost per channel