Thor 1- 4 HDMI to QAM Modulators - Manual (Page 15)

H-4SDI-or-4HDMI-QAM-IP
 Cable: indicate the modulation standard of this device is DVB-C.
 A: the symbol of different carrier output. “A”, “B”, “C”, and “D” alternate
constantly with the following output frequency.
 XXX.XX MHz indicates the current output frequency (range: 30~960MHz) of its
corresponding carrier output.
 P1: Program 1; P2: Program 2; P3: Program 3; P4: Program 4
 X.XX Mbps: indicate the encoding bit rate of each channel respectively.
3.3 General Settings for Main Menu
Press “Lock” key on the front panel to enter the main menu. The LCD will display the
following pages where user can configure the parameters for the device:
User can press UP/DOWN buttons to specify menu item, and then press ENTER to
enter the submenus as below:
1) Alarm Status
The alarm indicator will turn on if there is no A/V signals inputting or outputting bit
rate overflows. User then can enter this menu to check the error type.
2) Encode Setting
Under this submenu, the LCD will show “2.1 Input 1”, “2.2 Input 2” and “2.3 ASI”.
1 Alarm Status
2 Encode Setting 3 Modulate Setting
4 IP Output Setting
5 Network Setting
6 Saving Config 7 Loading Config
8 Version
2.1 Input 1
2.2 Input 2 2.3 ASI