Thor 1- 4 HDMI to QAM Modulators - Manual (Page 30)

H-4SDI-or-4HDMI-QAM-IP
Modulator Setting
Enter in “Modulator” and it will display the Modulator Configuration screen as
Figure-9 where can set modulation parameters.
RF On –To decide whether to enable the RF (carrier A/B/C/D) output or not.
Standard –Modulating standard selecting.
Constellation –QAM type selecting.
Symbol Rate – To set the symbol rate
RF Frequency A/B/C/D– to set the RF frequency for the 4 carriers
RF Out level –to set the RF output level
ASI Output– To select carrier output channel for ASI output (Output A: The ASI
output programs are same as carrier A; Output B: The ASI output programs are
same as carrier B; and the like.)
After setting all the parameters, click “Apply” to save the Modulator
Configuration.
Figure-9
Save/Restore
Clicking “Save/Restore” from the menu, it will display the screen as Figure-10 where
can save the configuration permanently to the device. Click “Save Configuration”,