D-Link DI-704UP - Manual (Page 45)

45
Using the Configuration Menu (continued)
Advanced > Routing
Static routes can be added if you require specific routes within your internal network.
These routes will not apply to the WAN network.
Hop Count - in a transmission path, each link is terminated at a network device
such as a router or gateway. The number of hops equals the number of routers or
gateways that data must pass through before reaching the destination.
Destination:
Enter in the IP of the specified network that you want to access using the static route.
Subnet Mask:
Enter in the subnet mask to be used for the specified network.
Gateway:
Enter in the gateway IP address to the specified network.
Hop:
Enter in the amount of hops it will take to reach the specified network.
Enable:
Select this option for the specified static route to take effect.