D-Link DI-704UP - Manual (Page 36)

36
Using the Configuration Menu (continued)
Advanced > IP Filter
Protocol:
Select the protocol type to block certain IP addresses.
IP Address:
Enter in the IP address range of the computers that you want the policy to apply to. If it
is only a single computer that you want the policy applied to, then enter the IP address of
that computer in the Start Source IP and leave the End Source IP blank.
Port Ranges:
Enter in the port range of the TCP/UDP ports that you want the policy to apply to. If it is
only a single port that you want the policy applied to, then enter the port number in the
Start Port field and leave the End Port field blank. If you want to use all the ports, you can
leave the port range empty.
Schedule:
Select Always, or choose From and enter the time period during which the IP filter policy
will be in effect.
Enabled / Disabled:
Click Enabled to apply the filter policy or click Disabled to enter an inactive filter policy
(You can reactivate the policy later.)