Pointmaker PVI 65 - Manual (Page 89)

Boeckeler Instruments, Inc. Pointmaker PVI-65 HD/SD-SDI Broadcast Video Marker - Page 79
Section Five: Using Markers Manipulating Overlays
M
ANIPULATING
O
VERLAYS
With the keyboard installed, you can display one of 10 stored marker overlays.
Also, you can temporarily turn off the marker overlay, without affecting the
markers you store there.
This section covers the following overlay functions:
• Paging Through Overlays (in sequence or out-of-sequence)
• Turning an overlay Off/On
Paging Through Overlays
Use these instructions when the keyboard is installed and you wish to display a
new overlay. After you display a new overlay you can add or clear markers
from that overlay. Overlays are saved automatically.
To go to the next or previous overlay
Activate the Next Overlay or Previous Overlay command. (see “Quick
Reference for Keyboard” in “Appendix” on page A-6)
The next or previous overlay of markers is displayed, and an overlay
# briefly appears in the corner of the screen.
To go to an out-of sequence overlay
1. Activate the Go To Overlay # command. (see “Quick Reference for
Keyboard” in “Appendix” on page A-6)
A small “#” sign appears in the lower-right corner, followed by an
underscore prompting you to type a number.
2. Type in the overlay number.
The overlay corresponding to the number appears. This selection is
confirmed by a brief display of the overlay number in the lower-right
corner of the screen.
NOTE: If you do not respond within a few seconds, the overlay does
not change.