Pointmaker PVI 65 - Manual (Page 85)

Boeckeler Instruments, Inc. Pointmaker PVI-65 HD/SD-SDI Broadcast Video Marker - Page 75
Section Five: Using Markers Clearing Markers
C
LEARING
M
ARKERS
After you anchor markers (drawings, lines, frames, and pointers), you may
want to clear the screen of all or some of the markers before proceeding to the
next point of discussion. You can erase markers in one of the three following
ways:
• Clearing All Markers
• Undoing the Most Recent Marker
• Erasing Markers
If you don’t want to clear markers, but just need to temporarily remove the
marker overlay, then use the Marker Overlay On/Off command (See “Turning
Off the Marker Overlay” on page 80).
Clearing All Markers
Follow these instructions to clear the entire screen of markers.
From the Digitizing Tablet
1. Select the CLEAR icon on the tablet Menu Strip.
All markers disappear. An active pointer remains on screen unless the
pointer was disengaged.
NOTE: Markers are cleared even if you are in PC Mode.
From Other Controllers
1. Activate the Clear command for your particular controller.
All markers disappear. An active pointer remains on screen unless the
pointer was disengaged.
Undoing a Marker
Follow these instructions to undo a marker, beginning with the most recently
anchored marker or line segment. You can repeat this command as often as
needed until the screen is clear of markers.