Initial preparation and disassembly – Paxton Superchargers Dodge V-10 Truck User Manual

Page 7

Section 2.0

INITIAL PREPARATION AND DISASSEMBLY

2-1

P/N: 4800019

25SEP03 v2.0 Dodge V-10(4800019v2.0)

Fig 2-a

Fig 2-b

Fig 2-c

n this section, you will be preparing for the
installation procedure by disconnecting the
battery cables and removing and relocating

a few pieces to make room for your new
Paxton supercharger.

2.1

INITIAL DISASSEMBLY AND
REMOVAL:

With a 1/2” wrench, remove both bat-
tery cables.

An 8mm wrench or socket is used to
remove the battery hold-down. Lift the
battery out of the tray and set it aside.

Unclip the cruise control cable from the
throttle body and mount if equipped.
(See Fig. 2-a.)

The tray is secured with two bolts and
two nuts above and two more accessible
from below. Use a 13mm socket with an
extension, and raise the battery tray
from the vehicle. (See Fig. 2-b.)

Use a 10mm wrench and remove the
cruise control actuator from the bottom
of the battery tray. Later it will be modi-
fied and reinstalled. (See Fig. 2-c.).

*** NOTE ***

On some later model trucks, the factory relocated
the cruise control actuator so this step will not need
to be done.