Supercharger installation and assembly – Paxton Superchargers Dodge V-10 Truck User Manual

Page 13

Section 3.0

SUPERCHARGER INSTALLATION AND ASSEMBLY

MODIFIED BRACKET

ORIGINAL PART

CUT LINE

LENGTHEN THIS HOLE

Fig 3-a

Fig 3-b

Fig 3-c

Use the supplied wire, wire loom and
butt connectors to extend the factory
harness to the cruise control module.
Cut off the plug leaving about 6” of
wire.

3.2

WINDOW WASHER BOTTLE

The washer bottle will be mounted on
the passenger side firewall. The wire
bracket must be bent in order for the
bottle to clear the A/C line running
across the firewall in that area. Bend an
offset in the bracket, set it in place and
mark the mounting holes. Use a 1/8”
drill and drill the two mounting holes.
(See Fig. 3-d.)

Secure the cruise control to the two
screws that secure the windshield wiper
motor, near the firewall and the washer
bottle. (See Fig 3-c.)

ow we start modifying various electrical
and mechanical assemblies as well as
beginning the supercharger installation.

***NOTE***

On some later model vehicles, this step will not
apply.

3.1

MODIFICATION AND INSTALLA-
TION

Modify the previously removed Cruise
Control bracket as shown.(See Figs. 3-a,
3-b.) It is not necessary to remove the
Cruise Control Actuator from the brack-
et.

3-1

P/N: 4800019

25SEP03 v2.0 Dodge V-10(4800019v2.0)