Paxton Superchargers Dodge V-10 Truck User Manual

Page 23

3-11

P/N: 4800019

25SEP03 v2.0 Dodge V-10(4800019v2.0)

Fig 3-gg

FRONT OF VEHICLE

DRILL

THROUGH

FLOOR 2x

CENTER

E-BRAKE

CABLE IN

NOTCH

ROCKER P

ANEL

V-10 DODGE FUEL SYSTEM MOUNTING PLATE

(Looking at underside of driver’s floor)

EMERGENCY

BRAKE CABLE

DRILL MOUNTING

HOLES THROUGH

SHEET METAL LIP

FRAME

Disconnect the factory fuel line from the
fitting. Connect the Auxiliary Fuel sys-
tem to the Factory Fuel line. (See Fig.
3-gg.)

Mark and drill the mounting holes with
a 1/4" drill.

Secure the auxiliary fuel system to the
floor pan with the supplied hardware.
Re-install the carpet and plastic trim in
the door jam. (See Appendix ‘I’.)

From underneath the vehicle, take the
two fuel lines from the auxiliary fuel
system and thread them above the frame
rail toward the fuel line.

Fig 3-ff

3.9

FUEL SYSTEM MODIFICATION

Open the driver’s door, remove the plas-
tic trim across the bottom of the door
jam and lift the carpet.

From under the vehicle, align the fuel
system mounting plate (Assembly
#1020101) Appendix “I” to the under-
side of the floor pan so that the notched
out section surrounds the parking brake
cable. (See Fig. 3-ff.)

***NOTE***

On some later mocel vehicles, you may have to
move the F/P mounting plate foreward for best fuel
hose routing.

Fig. 3-hh

3.10 BATTERY AND RADIATOR WRAP UP

Re-install the factory battery tray in the
stock location with the stock nuts and
bolts.

Install the battery with the factory hold-
down. Reconnect the cables

Connect the new upper radiator hose
extension to the end of the factory radia-
tor hose and to the radiator. Secure with
the supplied clamps. (See Fig. 3-hh.)

Fill the radiator with the fluid drained in
the beginning of the installation.