Paxton Superchargers Dodge V-10 Truck User Manual

Page 6

1-2

“PARK” or “FIRST”, the parking brake
engaged, and the wheels blocked.

• Never start the car without first verifying

that the transmission is in neutral and the
parking brake is set.

• Never remove the radiator cap while the

engine is still hot.

• Always wear eye protection when using

power tools such as drills, saws, grinders,
etc., or when working under a vehicle.

• Never smoke, use an open flame, or have

spark-producing items around gasoline or
flammable solvents. Always have a fire
extinguisher rated for chemical and electrical
fires handy when working on motor vehicles.

• Run engines only in a well ventilated area.

Carbon monoxide, gasoline and solvent
vapors are colorless, and sometimes odor-
less. These can asphyxiate or explode with-
out warning.

• Always disconnect at least the (-) negative or

ground terminal of the battery when doing
any electrical, fuel system, or under-dash
work.

We look forward to hearing from you, particu-
larly if you have any comments or suggestions
regarding this manual.

NOTE:

Throughout these procedures the word

“discard” is used periodically in relationship

to items that will no longer be utilized in

conjunction with the supercharger installa-

tion. It is recommended that these items

be saved for future use should it become

necessary.

P/N: 4800019

25SEP03 v2.0 Dodge V-10(4800019v2.0)

S F

IIN

TIIO

N::

9/16” Wrench
3/8” Ratchet
9/16” Socket 3/8” Drive
5/8” Socket 3/8” Drive
Pliers
Hacksaw
Wire Cutters
13mm Socket 3/8” Drive
10mm Socket
Long Extension
Wire Crimper/Strippers
13mm Wrench
Medium Extension
Drill Motor
1/8” Drill Bit
13/64” Drill Bit”
1/4” Drill Bit
5/16” Nut Driver or Slot Screwdriver
1/4” Allen Wrench or Socket
3/4” Socket
8mm Wrench
Hose Cutter or Sharp Knife
#2 Phillips Screwdriver
13mm Socket 3/8” Drive
Air Chisel/Hammer
Harmonic Balancer Puller
Power Steering Pulley/Puller Installer