Paxton Superchargers Dodge V-10 Truck User Manual

Page 10

2-4

P/N: 4800019

25SEP03 v2.0 Dodge V-10(4800019v2.0)

Fig 2-l

Fig 2-m

Fig 2-n

Fig 2-o

REAR VIEW

BEND DOWN

METAL LINE

SHOULD

LOOK LIKE

THIS AFTER

BENDING.

TOP VIEW

CAP

P/S/PUMP

DODGE V-10
POWER STEERING
PUMP HOSE
MODIFICATION

FLATTEN OUT

BEND IN

METAL LINE

Follow the accompanying instructions
with the power steering pulley
puller/pusher and remove the power
steering pulley. (See Fig. 2-l.)

Use a 15mm socket and remove the
three bolts securing the pump to the
bracket. (See Fig. 2-m.)

With a 9/16” socket and extension,
remove the four bolts that secure the
power steering bracket to the engine. Do
not disconnect the fluid lines.

On the back of the pump, remove the
two nuts with a 15mm wrench and the
two bolts with a 12mm socket. Remove
the bracket from the pump and lay the
pump on the steering box.

Grab the

power steering pump with both hands.
Bend the pressure line down until it is
flat, as shown. (See Fig. 2-n.)

Remove the bolt from the upper rod on
the A/C compressor with a 1/2” socket.
(See Fig. 2-o.)