Oil filter – Paxton Superchargers Dodge V-10 Truck User Manual

Page 19

3-7

P/N: 4800019

25SEP03 v2.0 Dodge V-10(4800019v2.0)

OIL

FILTER

SIDE

VIEW

STREET
“TEE” GOES
IN HOLE
FOR STOCK
SENDER

OIL PRESSURE
SENDER

1/8" PIPE

TO -48

DODGE V-10 OIL PRESSURE

SENDER/OIL FEED LINE

ANGLE SENDER TOWARD FRONT OF VEHICLE

SO IT CLEARS STEEL LINES AND SMOG PUMP

TO 12

Fig 3-r

Fig 3-s

Fig 3-t

Fig 3-u

Set the unit down into the bracket and
secure it to the bracket with the 5 sup-
plied 3/8-16 x 1.5” bolts, leave the third
hole from the top open. (See Fig.3-r,
Appendix ‘E’.)

J. Mount the supplied belt tensioner to

the mount with the large bolt, nut and
washer through the middle of the ten-
sioner. (See Fig. 3-t.)

From underneath the vehicle, secure the
other end of the oil drain hose to the fit-
ting on the oil pan with the supplied
hose clamp.

Install the supercharger belt tensioner
mount to the front of the supercharger
and the last open mounting hole in the
front of the bracket, using supplied spac-
er. (See Fig. 3-s, Appendix ‘F’.)

On the passenger side of the engine,
remove the factory oil pressure sensor
located above the oil filter. Replace the
sensor with the supplied street ‘TEE’.
Position the ‘TEE’ so that the sensor
will reinstall into the ‘TEE’ at an angle
pointing toward the smog pump. (See
Fig. 3-u.)