One Systems Natatorium - Manual (Page 7)

7
IT IS NECESSARY TO READ ESR 2948 AND UNDERSTAND THIS
DOCUMENT PRIOR TO INSTALLATION.
INSURE THAT THE SOLID CONCRETE CONFORMS TO SECTION
5.0 OF ESR 2948 AND OBSERVE ALL REQUIREMENTS IN THIS
“CONDITIONS OF USE” SECTION!
BRACKET LOCATION ON SOLID CONCRETE WALLS
IMPORTANT NOTE: The mounting holes in the concrete
MUST be drilled at least 8 inches (203.2mm) away from any
edges or openings in the solid concrete wall! DO NOT drill
the bracket mounting holes in the solid concrete where
wall edges or openings in the wall are closer then 8 inches
(203.2mm)!
Solid Concrete Anchors
:
If the 108IM/NAT or 112IM/NAT are to be mounted on a solid concrete surface, then
approved concrete anchors must be used. The ONLY approved source for concrete anchors
is Fischer Fixings LLC.
Do not substitute any other anchors!
The approved concrete anchors are as follows:
108IM/NAT Fischer FAZ II 10/10 C (the “C” is a designator for 1.4529 6% Mo stainless
steel)
112IM/NAT Fischer FAZ II 10/10 C (the “C” is a designator for 1.4529 6% Mo stainless
steel)