One Systems Natatorium User Manual

Page 12

NOTE: The required torque on the FAX II 10/10C M10 nut is 33 ft-lbf
(45 Nm). DO NOT EXCEED THIS TORQUE BUT INSURE THAT THIS
TORQUE IS APPLIED.

Once the FAZ II 10/10C nut is tightened to the specified torque, DO NOT re-torque
or tighten further. DO NOT re-torque later!

NOTE: DO NOT USE ANY THREAD LOCKER WITH THIS PRODUCT! Use ONLY
the parts supplied!

The contact information for Fischer is:

Fischer Fixings LLC
62 Orange Ave
Suffern, New York 10901

Phone: + 1-845-504-5098

NOTE: These anchors are NOT PERMITTED for use with “cinder block”
(CMU) construction! See information below for grout filled masonry
block.

Below is what is needed to hang a single 112/NAT or 108/NAT cabinet in a solid concrete
wall:

2 ea. NASH 1009007A FAZ II 10/10C Fischer anchors. One Systems Nashville supplied.

1 ea. Fischer air tool (Fischer part 89300…this part is re-useable). Fischer supplied

1ea. NASH 1009008A 10mm Masonry Drill Bit. One Systems supplied