One Systems Natatorium User Manual
Page 22
22
MOUNTING THE 108/NAT
NOTE: MOUNTING ON HOLLOW CORE BLOCK IS NOT
PERMTTED! DO NOT MOUNT ON HOLLOW CORE BLOCK!
MOUNT ON GROUT FILLED BLOCK ONLY!
NOTE: It is important to properly locate the NAT U-bracket on
the block wall. The 112/NAT and 108/NAT each require a
different mounting location relative to the concrete block cells.
The drilled thru hole must NOT be located near the edges of
the block or in the grout between the blocks. See the section on
page 13,
“BRACKET LOCATION ON GROUT FILLED BLOCK
WALLS
” for additional details.
NOTE: Only certain holes on the U-bracket may be used and
ONLY horizontal mounting is permitted. Drill only ONE
mounting hole per side.
Use ONLY one hole per side. Use either of the holes shown BUT not both holes.
NOTE: DO NOT DRILL MORE THEN ONE HOLE PER SIDE!
The images below show the mounting holes allowed.
Use these two holes ONLY!
OR
Alternately these two holes ONLY!