One Systems Natatorium - Manual (Page 10)

10
To install the FAZ II 10/10C anchor follow the steps listed below:
1. Create the drill hole. 3 11/32 (3.343 inches) deep (85mm) and 10mm diameter.
INSURE THAT THE HOLE IS THE CORRECT DEPTH!
This hole should be straight and perpendicular to the surface of the wall.
DO NOT drill at an angle!
Consult with someone with experience drilling into
solid concrete walls!
THE ACTUAL BRACKET LOCATION MUST BE AS NOTED ON PAGE
7 IN THE SECTION “BRACKET LOCATION ON SOLID CONCRETE
WALLS”!
NOTE: The hole diameter MUST be drilled with a 10mm diameter bit. Do not
substitute an imperial diameter. A metric 10mm diameter drill bit must be used!
ELECTRIC DRILLS MUST BE USED AND IN ROTATION MODE ONLY!
Note: One Systems offers the NASH 1009008A 10mm drill bit. This drill may be
sourced from One Systems Nashville.
2. Clean the hole completely using the tool shown below. It is important to
completely clean the hole. The cleaning operation should be performed several
times!
NOTE: It is critical to completely clean the drilled hole. It is necessary to follow the
anchor manufacturers cleaning instructions. See the recommended Fischer tool
(89300) below and may be sourced directly thru Fischer.