Graphics configuration, Amt configuration – NEXCOM NDiS M533 User Manual

Page 58

NDiS M533 User Manual

Chapter 4: BIOS Setup

Graphics Configuration

This section is used to configure the graphics parameters.

Primary IGFX Boot Display
Select the video device which will be activated during POST. Has no effect
if external graphics is present. Secondary boot display selection will appear
based on your selection. VGA modes will be supported only on primary
display.

Secondary IGFX Boot Display
Select the secondary display device.

Advanced

Boot

Security

Save

Exit

Main

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Select the Video Device which

will be activated during POST.
This has no effect if external

graphics present.
Secondary boot display
selection will appear based on
your selection.

VGA modes will be supported
only on primary display

Primary IGFX Boot Display

Secondary IGFX Boot Display

[Internal HDMI]

[External HDMI]

AMT Configuration

This section is used to configure Active Management Technology (AMT) options.

Advanced

Boot

Security

Save

Exit

Main

→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit

Enable/Disable Intel (R) Active

Management Technology BIOS
Extension.

Note : iAMT H/W is always
enabled.
This option just controls the
BIOS extension execution.

If enabled, this requires
additional firmware in the SPI
device

Intel AMT

BIOS Hotkey Pressed

MEBx Selection Screen

Disable ME

[Enabled]

[Disabled]

Intel

AMT

Enables or disables Intel

Active Management Technology.

BIOS Hotkey Pressed

Enables or disables BIOS hotkey press.

MEBx Selection Screen

Enables or disables MEBx selection screen.

Disable ME

Sets ME to Soft Temporary disabled.