NEXCOM NViS 3542 User Manual
Page 91
Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
74
Chapter 3: System Setup
NViS 3540/3540H/3540P4/3540P8 and NViS 3542/3542H/3542P4/3542P8 User Manual
Connecting to the Power Ignition Module (NISKIG120)
Introduction
The NISKIG120 is an external power ignition module that provides stable power to NViS 3540 series. Using this module will ensure that the device is well
shielded against premature failure at boot/shutdown phase. The following instructions will guide you on how to connect the NISKIG120 to the vehicle’s bat-
tery/ignition and NViS 3540 series.
The following instructions use NViS 3540P8 as an example, but
can be applied to all other NViS 3540 series.
1. Connect the vehicle battery and ignition to the module’s power input
socket, refer to the pin/wiring definition table below:
Close-up view of the power input:
Recommended wire gauge range: minimum of 10 AWG or above,
maximum length of 3 meters.
1
5