NEXCOM NViS 3542 - Manual (Page 85)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 68
Chapter 3: System Setup
NViS 3540/3540H/3540P4/3540P8 and NViS 3542/3542H/3542P4/3542P8 User Manual
Installing a Full Length SATA DOM
If you intend to install a full length SATA DOM, you may install
one SATA hard drive only.
1. Prior to installing the full length SATA DOM, remove any drive bay that
may have been previously installed.
2. Locate for the SATA connector on the board.
3. Align the SATA connector located on the solder side of the SATA DOM
to the SATA connector that is on the board and then press it down
firmly. Secure the SATA DOM with the provided mounting screw.
SATA DOM
Mounting screw
SATA connector
Solder side of
SATA DOM
4. Before installing the single drive bay back, you must first replace the 4
mounting studs.
Now place the single drive bay by aligning the mounting holes of the
drive bay with the mounting studs.
Mounting
hole