NEXCOM NISE 2400 - Manual (Page 72)

Copyright © 2015 NEXCOM International Co., Ltd. All Rights Reserved. 58 NISE 2400 Series User Manual
Chapter 4: BIOS Setup
PPM Configuration
This section is used to configure the Processor Power Management (PPM)
configuration.
EIST
Enables or disables Intel
® SpeedStep.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable/Disable Intel SpeedStep PPM Configuration
EIST [Disabled]
IdE Configuration
This section is used to configure the SATA drives.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable / Disable Serial ATA IDE Configuration
Serial-ATA (SATA)
SATA Mode
Serial-ATA Port 0
SATA Port0 HotPlug
Serial-ATA Port 1
SATA Port1 HotPlug
SATA Port0
Not Present
SATA Port1
Not Present
[Enabled]
[AHCI Mode]
[Enabled]
[Disabled]
[Enabled]
[Disabled]
Serial-ATA (SATA)
Enables or disables the SATA controller.
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.