Chapter 3: system setup, Removing the bottom cover, Hapter – NEXCOM NISE 2400 User Manual
Page 50: Ystem, Etup
Copyright © 2015 NEXCOM International Co., Ltd. All Rights Reserved.
36
NISE 2400 Series User Manual
Chapter 3: System Setup
C
haPter
3: s
ystem
s
etuP
Removing the Bottom Cover
1. With the bottom side of the chassis facing up, remove the mounting
screw on the bottom cover and then put them in a safe place for later use.
2. Lift up the cover and remove it from the chassis.
CAUTION!
CAUTION!
CAUTION!
Prior to removing the chassis cover, make sure the unit’s
power is off and disconnected from the power sources to
prevent electric shock or system damage.
Note:
Installation for SATA Hard Drive
This manual is related to the following products: