NEXCOM NEX 608 - Manual (Page 52)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 39
Chapter 3: BIOS Setup
NEX 608 User Manual
USB Mass Storage Device Configuration
Configures the USB mass storage class devices.
Number of seconds
POST waits for the
USB mass storage
device after start unit
command.
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay [20 Sec]
Device #1 USB Hotplug FDD
Emulation Type [Auto]
Advanced
USB Mass Storage Reset Delay
Selects the number of seconds POST waits for the USB mass storage device
after the start unit command.
Device #1
Displays the connected device.
Emulation Type
Auto USB devices that are less than 530MB will be emulated as
a floppy drive and the remaining as hard drives.
Forced FDD Forces an HDD formatted drive to boot as FDD (e.g. ZIP
drive)
ACPI Configuration
This section is used to configure the ACPI configuration.
Select the ACPI state
used for System
Suspend.
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
ACPI Settings
Suspend mode [S1 (POS)]
ACPI APIC Support [Enabled]
Advanced
Suspend Mode
This field is used to select the type of Suspend mode.
S1 (POS) Enables the Power On Suspend function.
S3 (STR) Enables the Suspend to RAM function.
ACPI APIC Support
Enables or disables the ACPI APIC function. It includes the ACPI APIC table
pointer to RSDT pointer list.