beautypg.com

NEXCOM NEX 608 User Manual

Page 49

background image

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved.

36

Chapter 3: BIOS Setup

NEX 608 User Manual

Disabled

Compatible

Enhanced

BIOS SETUP UTILITY

← →

Select Screen

↑↓

Select Item

+-

Change Option

F1

General Help

F10 Save and Exit

ESC Exit

IDE Configuration

ATA/IDE Configuration

[Enhanced]

Configure SATA as

[IDE]

u

Primary IDE Master

: [Not Detected]

u

Primary IDE Slave

: [Not Detected]

u

Secondary IDE Master

: [Not Detected]

u

Secondary IDE Slave

: [Not Detected]

u

Third IDE Master

: [Not Detected]

u

Third IDE Slave

: [Not Detected]

IDE Detect Time Out (Sec)

[35]

Advanced

IDE Configuration

This section is used to configure the IDE drives.

ATA/IDE Configuration

This field is used to configure the IDE drives. The options are Disabled,
Compatible and Enhanced.

Configure SATA As

IDE

This option configures the Serial ATA drives as Parallel ATA physi-
cal storage device.

AHCI

This option configures the Serial ATA drives to use AHCI (Ad-
vanced Host Controller Interface). AHCI allows the storage driver
to enable the advanced Serial ATA features which will increase
storage performance.

v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.

Select the type

of device connected

to the system.

BIOS SETUP UTILITY

v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.

← →

Select Screen

↑↓

Select Item

+-

Change Option

F1

General Help

F10 Save and Exit

ESC Exit

Primary IDE Master

Device

:Not Detected

Type

LBA/Large Mode

Block (Multi-Sector Transfer)

PIO Mode

DMA Mode

S.M.A.R.T.

32Bit Data Transfer

Advanced

[Auto]

[Auto]

[Auto]

[Auto]

[Auto]

[Auto]

[Enabled]

Primary IDE Master to Third IDE Slave

When you enter the BIOS Setup Utility, the BIOS will auto detect the ex-
isting IDE devices then displays the status of the detected devices. To con-
figure an IDE drive, move the cursor to a field then press .