Knox Video RSIII - Manual (Page 6)

Table of Contents
SECTION 1. GENERAL INFORMATION
1.1 INTRODUCTION
1.2 TECHNICAL DESCRIPTION
1.3 DETAIL SPECIFICATIONS
SECTION 2. INSTALLATION
2.1 INTRODUCTION
2.2 UNPACKING AND INSPECTION
2.3 INSTALLATION
2.4 VIDEO CONNECTIONS
2.5 AUDIO CONNECTIONS
2.6 CAT CONNECTIONS
2.7 EXTERNAN COMMUNICATIONS
2.7.1 RS-232 CONNECTION
2.7.2 RS-422 CONNECTION
2.7.3 ETHERNET CONNECTION
SECTION 3. OPERATION
3.1 INTRODUCTION
3.2 CONNECTIONS
3.3 CONTROL VIA THE FRONT PANEL
3.3.1 DISPLAYING THE CROSSPOINT CONNECTIONS AND VTB VALUES
3.3.2 CHANGING A CROSSPOINT CONNECTION
3.3.3 USING THE MUTE BUTTON
3.3.4 ADJUSTING VOLUME AND TONE WITH THE ROTARY SWITCH
3.4 CONTROL VIA THE SERIAL RS232/RS422 PORT OR ETHERNET PORT
3.4.1. LETTER COMMANDS – SWITCHING CHANNELS
3.4.1.1 ROUTING AUDIO AND VIDEO
3.4.1.2 USING THE CONFERENCE MODE
3.4.1.3 USING THE SALVO MODE
3.4.1.4 USING THE QUEUE MODE
3.4.2 CROSSPOINT STATUS AND CONFIGURATION COMMANDS
3.4.2.1 DISPLAY OR DUMP COMMAND
3.4.2.2 CLEARING ALL CONNECTIONS
3.4.2.3 USING PATTERNS
3.4.2.4 IMMEDIATELY CORRECTING INADVERTENT COMMANDS
3.4.2.5 OBTAINING INFORMATION ABOUT THE SWITCH
3.4.3 $ COMMANDS - CONTROLLING THE SOUND
3.4.3.1 VOLUME CONTROL
3.4.3.2 BASS AND TREBLE CONTROL
3.4.3.3 BALANCE CONTROL
3.4.3.4 MUTE CONTROL
3.4.3.5 LOUNDESS CONTROL
3.4.3.6 SETTING ZONE GROUPS FOR VTB CONTROL
3.4.4 AUDIO STATUS AND CONFIGURATION COMMANDS
3.4.4.1 DISPLAY OR DUMP COMMAND
3.4.4.2 CLEAR COMMAND
SECTION 4. MAINTENANCE
4.1 INTRODUCTION
4.2 CLEARING THE MEMORY