Knox Video RSIII - Manual (Page 18)

To conference video only, send a command in the form:
Kxy [ENTER]
Kxxyy [ENTER]
Kxxxyyy [ENTER]
Where x specifies the first location’s video while y specifies the other location’s video.
To conference audio only, send a command in the form:
Lxy [ENTER]
Lxxyy [ENTER]
Lxxxyyy [ENTER]
Where x specifies the first location’s audio while y specifies the other location’s audio.
3.4.1.3 USING THE SALVO MODE
It is possible to send the same input to a number of consecutive outputs using the Salvo
command.
The X command sends both video and audio to the range of outputs.
Xmno [ENTER]
Xmmnnoo [ENTER]
Xmmmnnnooo [ENTER]
Where m is the first output number, n is the last output number, and o is the input number.
The Y command sends video only to the range of outputs.
Ymno [ENTER]
Ymmnnoo [ENTER]
Ymmmnnnooo [ENTER]
Where m is the first output number, n is the last output number, and o is the input number.
The Z command sends audio only to the range of outputs..
Zmno [ENTER]
Zmmnnoo [ENTER]
Zmmmnnnooo [ENTER]
where m is the first output number, n is the last output number, and o is the input number.
For example,
Y010408 sends the audio from input 8 to outputs 1 through 4.
3.4.1.4 USING THE QUEUE MODE
Sometimes it is necessary to have a number of switches made all at the same instant. It is
possible to queue a number of pattern changes ahead of time, then to have them all executed at
once. In the queue mode it is possible to send a set of commands to the RSIII that will be held
until the final command is received, then all the commands are performed at the same time. The
E, F, and G commands are used to synchronize the switching of multiple events. These
commands are stored in the queue until the EE command is given to implement all changes.
The E command queues both video and audio commands.
Emn [ENTER]
Emmnn [ENTER]
Emmmnnn [ENTER]
where m is the output number, and n is the input number.
The F command queues video only commands.