Knox Video RSIII - Manual (Page 21)

MAC ADR: 00-20-4A-A6-B6-2B IP ADR: 192.168.168.48
DONE
The first line of the information is the Knox Video Technologies copyright notice. The second
line is the nomenclature describing the unit. This particular unit is a series RSIII model RGBHV
with 12 input channels and 8 output channels of video that has BNC connectors on the rear panel
for input. The audio is unbalanced stereo with the optional Volume Tone Board installed with 12
input and 8 output channels. There is an optional two channel CAT 5 cable driver and is
controllable via TCP/IP. The third line contains the firmware revision level whether or not a sync
signal was detected and a unique ID number. The fourth line is the unit’s serial number. The fifth
line displays the MAC address and Internet address.
3.4.2.6 HELP WITH COMMAND SYNTAX
Information on specific commands can be found while communicating with the switch. Send the
H command and a summery of the commands will be displayed. Sending an Hx, where x is a
command name, will display specific help about using that command.
H [ENTER] Summary of help command
Hx [ENTER] Specific help on command x
H [ENTER]
Crosspoint Commands: Misc. Commands:
B Follow Switch H General Help Display
A Audio Breakaway Hx Specific Help on Command 'x'
V Video Breakaway I Sign on Message
Q Split Switch IP Change Network Parameters
E Delayed Follow Switch UNDO undoes the previous command
F Delayed Video Switch / Change Ethernet
Username/Password
G Delayed Audio Switch
C Clear all Crosspoints
J Conference Audio & Video VT Commands:
K Conference Video only $D Display $M Mute
L Conference Audio only $V Volume $L Loudness
X A/V to Multiple Outputs $B Bass $Z Zone
Y Video to Multiple Outputs $T Treble $S Balance
Z Audio to Multiple Outputs $C Clear $I Input Trim
Pattern Memory Commands: Display Crosspoint Matrix Commands:
S Store Pattern D Display in single format
R Recall Pattern DL Display in multicolumn format
M Display Patterns DR Display Range of Matrix
3.4.3 $ COMMANDS - CONTROLLING THE SOUND
If the optional VT board (VTB) is installed, an external controller can control the volume, tone
and balance of any channel by sending a $ command.
3.4.3.1 VOLUME CONTROL