Knox Video RSIII - Manual (Page 19)

Fmn [ENTER]
Fmmnn [ENTER]
Fmmmnnn [ENTER]
where m is the output number, and n is the input number.
The G command queues audio only commands.
Gmn [ENTER]
Gmmnn [ENTER]
Gmmmnnn [ENTER]
Where m is the output number, and n is the input number.
The final command in the set of commands must be EE. When the EE command is received all
previous commands that are in the queue are executed.
For example, the following consecutive command sequence was sent over some period of time.
F10 [ENTER] G42 [ENTER] EE [ENTER] will queue the video on output 1 to turn off
and route the audio on input 4 to output 2.
3.4.2 CROSSPOINT STATUS AND CONFIGURATION COMMANDS
3.4.2.1 DISPLAY OR DUMP COMMAND
To determine the condition of a particular crosspoint or group of crosspoints use the D command
of the form:
D Display Entire Crosspoint Matrix in single group
DL Display Entire Crosspoint Matrix in Multicolumn Format
DRxy Display Range of Crosspoint Matrix in single group
DRxxyy
DRxxxyyy
Where x is the starting output channel and y is the ending output channel.
The
D command will dump all crosspoint connections in three columns: the output channel the
video input channel and the audio input channel that is connected to that output.
D[ENTER]
001 V007 A007
002 V007 A007
003 V007 A007
004 V006 A006
005 V004 A004
006 V002 A001
007 V001 A001
008 V000 A000
DONE
The
DL command will break the display into a multi column output with headings above the
columns. It will try to use as much as the screen’s width as possible. This will allow the operator
to see more connections on a given screen.
DL[ENTER]
Out Video Audio Out Video Audio Out Video Audio Out Video
Audio
1 003 003 5 000 000 9 000 000 13 000 000
2 005 011 6 000 000 10 000 000 14 000 000
3 004 001 7 000 000 11 000 000 15 000 000