Knox Video RSIII - Manual (Page 14)

At this point unplug the power to the RSIII wait 10 seconds and then plug the RSIII back in.
After the RSIII initializes itself the terminal program will display the message:
*****************************************************
** Network Configuration **
*****************************************************
IP Address:
And will be waiting for input. Available settings are the RSIII's IP, Gateway, Netmask, and Port
Number. The IP and Gateway must be valid IP addresses or it will not be accepted. If an RSIII
configured with DHCP is desired set the IP address to 0.0.0.0. The netmask can range from 0 to
31. Valid Port Numbers range from 1 to 65535, but 1 to 1024, 9999, 14000 to 14009, 30704, and
30718 are restricted from use.
Enter the information requested (
[ENTER] represents the enter key).
IP Address: 192.168.48.1[ENTER]
Gateway Address: 192.168.1.1[ENTER]
Netmask: 24[ENTER]
Port: 3001[ENTER]
Once properly configured access to the RSIII can only be gained by use of a user login and
password. The default username is
admin and the default password is pswd . To change the
username or password, send the command /[ENTER] to the RSIII. The RSIII will respond by
asking for the current user name and password; once accepted, it will prompt for the new
username and password. If the username and password were changed while connected via the
Ethernet the user will be logged off and will have to login again with the new username and
password.
The MAC address of the switch can be found by sending the
I command to the switch. The unit
will return various information (see paragraph 3.4.2.5), which includes the MAC and IP address.