KLING & FREITAG K&F ACCESS T9 - Manual (Page 33)

User’s Manual ACCESS SYSTEM
KLING & FREITAG GMBH ©1995-2009 Version 6.0, 17.03.2009 Page 33 of 60
9.2 Connectors of the Bass Connector Panels CP1-B und CP3-B
3) CP1-B
This model is designed to be connected to a 230 V mains supply.
The model with the code number ‘1‘ is recognizable by its power supply cable with
the blue plug on the front side of the equipment.
(CEE 16 A, 3-pin, 230 V, 6 h)
4) CP3-B
This model is designed to be connected to a three-phase supply current with 230 V
per phase. The model with the code number ‘3‘ is recognizable by its power supply
cable with the red plug on the front side of the equipment.
(CEE 16 A, 5- pin, 400 V, 6 h)
Front
1 2 4 5 6 3
BASS SPEAKER OUT
2
3
1
NEUTRIK
PUSH
1 3 2
NEUTRIK
INPUT LINK BASS OUT
GROUND
ON OFF
MAINS
ACCESS
1
2 3 4
5
2
3
1
NEUTRIK
PUSH
1 3 2
NEUTRIK
1 3 2
NEUTRIK
1
2 3 4
5
L / +
N
1) INPUT
Balanced XLR input connector (female) for the input signal (e.g. the signal from the
mixing console)
2) INPUT --- LINK
Balanced XLR output connector (male) to link the input signal to other devices
3) GROUND LIFT
The Ground Lift switch serves to avoid ground loops. If the Ground Lift switch is set
on LIFT, then the Pin 1 (ground) of the input connector is not connected to Pin 1 of
the cable IN on the rear of the unit. There is always a connection between the input
connector (XLR-female) and the link connector (XLR-male).
4) BASS OUT
This output provides the optional transmission of the bass signal supplied by the
C5/9 Controller (LINE) to an additional power amplifier.
5) BASS SPEAKER OUT
The bass speaker(s) are connected to these EP-5 connectors (female). Both connec-
tors are wired in parallel (no stereo signal!)
6) Central Power Supply Cable
6a) The connector panel CP1-B is equipped with a CEE connector 16A, 3-pin,
230V, 6h and serves as a connection to a 230V mains supply. With this
model, a total of max. 16A can be connected to the 6 junction boxes.
6b) The connector panel CP3-B is equipped with a red CEE connector 16A, 5-pin,
400V, 6h and serves as a connection to a three-phase current supply with 230V
per phase. Please see also topic 7 on the next page.