Junger Audio d07 - Digital Transmission Processor - Manual (Page 57)

B 6 – Network Integration
You will get to the Hyper terminal window:
Press and you will get the following information of the device:
Now you can change the network configuration so that it fits into your LAN.
You might have changed the IP-address of the device, so please renew the label at
the rear of the device, otherwise it will cause confusion.
When you ever initialize the device the default IP-address and network
configuration will be active again. In case of need you can read the default IP-
address always on the controller inside the device!
B)
You can also change the IP address of the device over Ethernet connection.
Disconnect your PC from the LAN, connect it to the device directly via
Ethernet crossover cable. Change the network configuration of your PC
(write down the current settings, you need them later to reconnect to your
LAN!)
via “Local Area Connection Properties” (Windows: Start -> Settings ->
Network connections -> Local Area Connections)