C8621, C8000, Digital audio modular processing system – Junger Audio C8621- Dolby® D/D+/E Decoder & Metadata Generator User Manual
Page 7: Dolby, E / d / d plus decoder, Page 7/19

digital audio
modular
processing system
C8000
Dolby
®
E / D / D plus decoder
C8621
Page 7/19
DOLBY METADATA
Since the C8621 also offers a metadata generator a bank of 16
presets to recall Dolby metadata parameters is implemented.
Load
[1: "name" … 16: "name"]
Select a preset by number/name and press
The preset number and name loaded will automatically appear in
the Save as # and Name field below.
Programs loaded
[Prog 1 – preset name xy … Prog 4 – preset name xy / common]
from preset
Shows the preset name and number [xy] from which the
respective program metadata or common ones (e.g. Dolby E
frame rate, program configuration etc) have been loaded.
Initially the preset names and numbers are empty, represented
by a dash.
Important Note! The metadata structure of the c8k system is defined for a maximum number of four
supported programs. I.e. the metadata generator will generate up to four independent sets of metadata
for a RDD6 compliant stream. If derived from the Dolby decoder the generator will enter the reversion
mode if the number of programs of the Dolby E stream received does not match this definition.
Save as #
[1 … 16]
You must elect a preset memory number where you would like to
save the actual metadata parameters.
Name
[16 character ASCII text]
Assign a name to the preset you are about to save here.
Programs to include
Tick the check box(es) for which program this preset shall be
in preset
saved and press
The number and the name appear automatically in the "Load"
fields as well because they are active now.
DECODER SETUP
Refers to the DECODE pane
Load
[17: "name" … 32: "name"]
Select a preset by number/name and press
The preset number and name loaded will automatically appear in
the Save as # and Name field below.
Save as #
[17 .. 32]
Select a preset memory number where you
would like to save the actual audio program parameters.
Name
[16 character ASCII text]
Assign a name to the preset you are about to save
(up to 16 digits) and press
SETUP/INPUT BUS ROUTING
Refers to the SETUP / ROUTING pane
(FROM C8000 BUS)
A bank of 8 presets to recall device settings.
Load
[33: "name" … 40: "name"]
Select a preset by number/name and press
The preset number and name loaded will automatically appear in
the Save as # and Name field below.
Save as #
[33 … 40]
Select a preset memory number where you would like to save
the actual audio program parameters.