Junger Audio C8621- Dolby® D/D+/E Decoder & Metadata Generator - Manual (Page 11)

digital audio
modular
processing system
C8000
Dolby
®
E / D / D plus decoder
C8621
Page 11/19
SETUP/ROUTING: Setup of the module and the audio bus routing
BNC Input
You may connect an AES signal to the BNC front panel connector that
carries an encoded Dolby stream.
From C8000 System Bus
8 Ch Mux [S1 … S32]
Selection of a backplane bus that carries an eight channel multiplex.
The check boxes select which pair from the multiplex stream will feed the
respective input(s) of the DECODER.
Ch 1/2 … Ch 7/8
[S1 … S32]
Here you may select the inputs of the decoder. The radio button on the
first input selects between this bus selector and the front panel BNC
connector. An extra delay is provided for a 2Ch PCM signal. The delay
can be used to match the Dolby decoding latency for a stereo program.
It may also be used to delay subset metadata from the decoder output
(subset metadata are automatically attached to all PCM audio outputs
from Ch 1/2 to Ch 9/10 of the module).