Junger Audio C8621- Dolby® D/D+/E Decoder & Metadata Generator - Manual (Page 4)

digital audio
modular
processing system
C8000
Dolby
®
E / D / D plus decoder
C8621
Page 4/19
Installation:
Set the ADDRESS rotary encoder to an address, which is not in use by another module
of a C8000 frame (for details regarding CAN addressing, see C8k system manual).
BUS-EN = OFF will disable the bus driver circuits on power up
SW-1B = not used, must be OFF
SW-1C = not used, must be OFF
ID +16
= ON enables the CAN “+16” address scheme to handle up to 32 modules
Important Note! If the module has an unknown bus configuration, you must set BUS-EN=OFF, before
inserting the module into a C8000 frame. Otherwise you risk disturbing other channels of the frame.
When you press the INIT button during power up, it will initialize the module parameters to factory
default values.
Status LEDs:
On the front panel are 3 status LEDs:
STATUS
green = OK
red = bad
flashing = module is in focus of the frame controller (under GUI control)
Decoding green = the decoder reads a proper Dolby encoded signal
off = no Dolby encoded signal is present
ADDRESS
ID +16
O
N D
IP
1 2
3
4
BUS-EN
SW1
INIT
FAIL
B
O
O
T
B
D
S
GND