Junger Audio C8491 - Compact Card - Manual (Page 6)

digital audio
modular
processing system
C8000
3G/HD/SD-SDI – DSP 4/8/16 audio channels
C8491
page 6/21
Channels stored
the soft LEDs show the channels which will be controlled by the
in presets active preset. The check boxes define which channels will be
stored when you save a preset.
The total number of channels which will be displayed (upper soft
LED line) or masked (lower line of check boxes) depends on the
operating mode of the DSP and the link condition of the channels
involved in a program.
Here an example for DSP1 (Ch 1 – 8) set for 5.1 + 2 operating
mode and DSP 2 (Ch 9 – 16) is set for 4 x 2 operating mode
while Ch 9/10 and 11/12 are linked for stereo operation and
13 -14 as well as 15 – 16 are not linked.
SDI
controls the SDI Embedder / De-Embdder including delays
Load select a preset by name and press .
Save as # select a preset NV memory number.
Name assign the preset a name (up to 16 digits).
and press .
Failover / Upmix the third group (#33 … #40) is intended for fail over and upmix
parameters.
Load select a preset by name and press .
Save as # select a preset NV memory number.
Name assign the preset a name (up to 16 digits).
and press .
Processing blocks you can select the processing blocks will be stored in a preset.
Stored in presets I.e. you can change the parameters for one 2ch fail over without
changing the parameters for another one:
The number of processing blocks involved, depends on the
operating mode for the DSPs.
Preset Clipboard copy the active preset to a clip board, the data may be used by
other modules inside the same frame.
Backup Presets to File creates a backup XML file which may be saved on a PC.
Restore Presets from File you can select a backup file from a PC and restore the set of
presets.