Doremi DCP to ShowVault Conversion Procedure - Manual (Page 20)

Figure 46: Dolphin Stand-off on 1.2 F Dolphin
Figure 47: Motherboard Screw on 1.2 F Dolphin
• Remove the 1 GB RAM modules from the motherboard by pressing down on the white
latches on the side of the RAM slots to release the modules (Figure 48). Lift the modules
out of their slots.
◦
Note : This step is only necessary if the unit does not already have the 2GB RAM
modules. If the unit already has the 2GB modules, then skip this step. If it has the
1GB modules, then you must update to the 2GB modules provided. To determine if
the RAM modules in your unit are 2GB, look at the sticker on the modules. It should
state “2G” at the end of a long series of letters and numbers (Figure 49).
Figure 48: RAM Slots
SHV.DP.001968.DRM Page 20 Version 1.2
Doremi Cinema LLC Confidential
Motherboard
screw in
place
Dolphin
stand-off
RAM
modules
White
latches