Doremi DCP to ShowVault Conversion Procedure - Manual (Page 11)

5 Conversion Procedure
• The lid needs to be removed. Unscrew the six screws with the Phillips screwdriver.
There are two screws on each side and two screws on the rear panel of the chassis
(Figure 19).
Figure 20: DCP-2K4 Lid Removed
• Once the lid has been properly removed, proceed to remove the Dolphin card by
unscrewing the screw holding the Dolphin card in place on the motherboard (located at
H5J1 for the 1.2 Dolphin and H5G1 for the 1.0 Dolphin), with the Phillips screwdriver.
See Figure 21 for the 1.2 F Dolphin and Figure 22 for the 1.0 E Dolphin.
Figure 21: Screw on Motherboard: 1.2 F Dolphin
SHV.DP.001968.DRM Page 11 Version 1.2
Doremi Cinema LLC Confidential
Motherboard
Screw