DekTec DTE-3114 IP to 4x QAM - Manual (Page 49)

DTE-3114 – Networked Quad QAM Modulator
USER MANUAL
49
outModulationStandard OBJECT-TYPE
SYNTAX INTEGER {
dvbc(0),
j83AnnexB(1),
j83AnnexC(2)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Modulation standard used for this channel.
0 dvb-c (j83-annex-a)
1 j83-annex-b
2 j83-annex-c"
::= { outEntry 6 }
outQamMode OBJECT-TYPE
SYNTAX INTEGER {
qam32(5),
qam64(6),
qam128(7),
qam256(8)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"QAM mode (number of constellation points) used by this channel.
5 32-QAM
6 64-QAM
7 128-QAM
8 256-QAM"
::= { outEntry 7 }
outSpectralInversion OBJECT-TYPE
SYNTAX INTEGER {
disable(0),
enable(1)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Enable or disable spectral inversion.
0 disable spectral inversion
1 enable spectral inversion
"
DEFVAL { disable }
::= { outEntry 8 }
outInterleaverI OBJECT-TYPE
SYNTAX Integer32
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"If the modulation standard is j83-annex-b, this settings specifies
interleaver parameter I."
::= { outEntry 9 }
outInterleaverJ OBJECT-TYPE
SYNTAX Integer32
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"If the modulation standard is j83-annex-b, this settings specifies
interleaver parameter J."
::= { outEntry 10 }
outRfLevel OBJECT-TYPE
SYNTAX Integer32
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"The desired RF output level in tenths dBmW for this channel."
::= { outEntry 11 }
outSettingsStatus OBJECT-TYPE
SYNTAX Integer32
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Modulator Channel status. The status is either 'ok' or an error code.
If multiple errors are active, the status code with the lowest value
is reported. When the error condition is resolved, but another error
is still present, then the corresponding error code will appear. See
Error Settings table.