DekTec DTE-3114 IP to 4x QAM - Manual (Page 17)

DTE-3114 – Networked Quad QAM Modulator
USER MANUAL
17
Variable Description Web SNMP
Device status Reflects the status of the device:
 Normal operation. The device is working properly.
 Hardware error. A serious and fatal error has occurred
in the hardware. The DTE-3114 cannot be used and
should be returned to the supplier.
 Channel error. One or more of the four QAM-
modulator channels is in an error state. See “Channel
operational status” in section 3.2.5.
 Temperature error. The internal temperature of the
DTE-3114 is too high (> 85˚C/185˚F). The RF output
is automatically disabled to reduce heat dissipation.
When the temperature drops below 85˚C/185˚F
again, the RF output will be enabled again.
NA RO
Synchronise settings Writing to this object will synchronize the value of the MIB
objects with the current run-time settings, see
section 3.4.2
NA WO
3.2.2 Network Settings
Variable Description Web SNMP
MAC address The MAC address of the device RO RO
DHCP enable Indicates whether the DTE-3114 shall obtain an IP
address through DHCP or whether a fixed IP address
shall be used
R/W NA
IP address IP address to use (fixed IP address mode) R/W RO
Subnet mask Identifies which part of the IP address is reserved for the
network, and which part is available for host use (fixed IP
address mode)
R/W RO
Default gateway Identifies the IP address of the gateway that is used to
route IP packets that are not located on the current subnet
(fixed IP address mode)
R/W NA
SNMP agent
Enable Enable or disable SNMP agent R/W NA
Read community String that is used as a password to enable reading of
parameters via SNMP
R/W NA
Write community String that is used as a password to enable writing of
parameters via SNMP
R/W NA