DekTec DTC-315 DtEncode - Manual (Page 23)

DTC-315
© 2009-2014 DekTec Digital Video BV Page 23/29 Manual for DTC-315 DtEncode Software
Essential Tools for Digital-TV Professionals April 2014
Appendix D: DtEncode specific output controls for ATSC
(*)
When using adapters that supports ATSC modulation, a detailed configuration window permits to
fine tune the RF output.
DTA-115’s ATSC RF output settings window
Item1 Item2 Explanation
RF Output For RF parameters
Frequency This is output frequency [MHz] of the RF modulator.
You can enter directly the value or use the spin button.
(Check your hardware specification for available range of values)
Level This is output level [dBm] of the RF modulator (**).
You can enter directly the value or use the spin button.
The value should be between -27dBm and +3dBM
Modulation For the Modulation parameters
Modulation You can select 8VSB or 16VSB
Taps The Taps permit to define a level of perfection for the modulation.
Values range from 4 (lower quality, low CPU load) to 64 (best quality, high CPU
load). (4, 8, 16, 32, 64)
(*) This is available if your output adapter support this RF output.
(**) This is only available for DTA-115, DTA-112 and DTA-2115 output adapters.