Dan Dugan Sound Design D-3 - Manual (Page 20)

Dugan Model D-3 User Guide Installation
20
Figure 2-2 Side and rear control connections
4. Reset the Processor by positioning the cursor under
RESET
and pressing the
center
ENTER
button.
5. Look at the front panel LCD display and check that the Processor is set to
MASTER
mode. If it is not, use the left and right keys to position the cursor
under
SLAVE
, and press the
ENTER
key to toggle
SLAVE
to
MASTER
.
6. Set all rotary knob controls on their yellow marks.
7. De-activate the
music system
,
NOM
, and
override
buttons on each channel.
8. Select
group a
on each channel by pressing the
group
button until the
a
LED
lights.
9. Activate the
auto
button for all channels in use.
10. Select the
mute
mode for unused channels.
11. Press the
preset
button until the LED to its left matches the setting in step 10.
2.2 Audio Wiring
2.2.1 Inputs
The eight channel inputs and the Music System threshold inputs are female AES XLR
receptacles (pin 1 = shield, pin 2 = +, pin 3 = -). Average program levels from -42 to
-16 dBFS are within the acceptable range; -20 dBFS is optimal. The
level
lights are
green for all levels in normal operation, and flash red at 0 dBFS.