Dan Dugan Sound Design D-3 - Manual (Page 19)

Dugan Model D-3 User Guide
19
Chapter 2: Installation
All users should complete all steps in this chapter.
2.1 Setup
1. Install the Processor in a rack convenient for wiring to the console’s insert
points.
2. Position the Control Panel in a convenient place in the mixer’s line of sight.
Rack ears can be removed. The Control Panel can be placed flat on the table in
front of the console, or on the meter bridge. There are four threaded holes on
the rear panel for custom mounting brackets.
Figure 2-1 Control Panel in front of mixer
3. Connect the Control Panel to the
CTRL
connector on the Processor rear panel
with the five-pin XLR cable. The Control Panel has two parallel connectors:
one on the back and one on the left. Only one may be used at a time.