Dan Dugan Sound Design E-1 - Manual (Page 18)

Dugan Models E-1 and E-1A User Guide
18
The Model E-1A has two digital operating modes:
• 8 ch: Eight automxing channels, linking possible
• 16 ch: Sixteen automixing channels, no linking
The LINK IN and LINK OUT connectors are reassigned as audio I/O for channels
9–16.
To set 16 ch mode, you can use the Dugan Control Panel (see Chapter 4: Dugan
Control Panel), or a key command during startup (see Configuration on page 20).
Since the Model E-1A’s front panel provides only eight channels, we strongly rec-
ommend using the Dugan Control Panel to operate in 16 ch mode.
NOTE: Due to the Model E-1A’s compact size and close spacing of the ADAT connectors, some large
cables may not fit. The maximum cable width is 0.48 in (12 mm).
3. On your digital console’s patch configuration screen, patch the ADAT channels
as post-fader inserts.
If all mute buttons blink, there is no digital input signal.
Figure 3-5 Post-fader insert example from Yamaha 01V96