Dan Dugan Sound Design E-1 - Manual (Page 11)

Dugan Models E-1 and E-1A User Guide
11
Chapter 2: Quickstart
This section provides step-by-step instructions to help you get started quickly. It in-
cludes information to connect and install the Model E-1A, make initial settings, and
link units.
Connections
1. Connect the provided power supply to the Model E-1A.
2. Set the NORM-SLAVE switch on the rear panel to NORM (up) for normal (not linked)
operation.
The Model E-1A can be interfaced with an analog or digital console using analog
or digital connections.
Analog I/O
1. Move the I/O switch on the rear panel to the ANALOG (up) position.
The Model E-1A is a line-level device normally patched into the insert jacks (send
and return) for each mic input channel on the board.
2. Check the insert jack wiring on your console.
If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS insert ca-
bles to connect the Model E-1A. Other configurations require special cables. The
Model E-1A is wired as follows: tip = input, ring = output.
Figure 2-1 Analog connection