Dan Dugan Sound Design E-1 - Manual (Page 12)

Dugan Models E-1 and E-1A User Guide
12
Digital I/O
Figure 2-2 Digital audio connectors (left), typical patch in Yamaha O1V96 (right)
1. Move the I/O switch on the rear panel to the DIGITAL (down) position.
2. Connect the console ADAT output to the Model E-1A AUD IN, and the Model E-1A
AUD OUT to the board’s ADAT input.
3. Using the console’s patching system, insert the ADAT inputs and outputs on each
mic channel, post-fader.
The Model E-1A can now transmit and receive eight channels to and from the
console.
If all mute buttons blink, there is no digital input signal.
NOTE: The Model E-1A (not the Model E-1) can use the LINK IN and LINK OUT connectors for
eight additional automatic mixing channels.
NOTE: Due to the Model E-1A’s compact size and close spacing of the ADAT connectors, some large
cables may not fit. The maximum cable width is 0.48 in (12 mm).
Power-up Reset Command
The Model E-1A can execute five commands during power-up. Each command is se-
lected by holding down a specific button during the entire power-up process. Power-
up is complete after the front panel LEDs stop flashing.
The most important power-up command is Reset. See Configuration on page 20 to learn
about the additional commands.