d&b D80 - Manual (Page 54)

EQ overview
The upper part of the overview provides the overall frequency
response of all filters while «EQ 1» is displayed in red and «EQ 2»
in yellow.
Active filters are displayed by continuous lines and the curves are
filled with grey color while inactive filters are displayed by dashed
lines.
The bottom part of the overview provides the following functions:
EQ [n]
On/Off
Master On/Off switch for the respective EQ.
Edit Opens the corresponding subscreen (EQ
layer/curve) for editing.
Clear... Resets all filter settings of the corresponding
EQ.
To prevent accidental reset when you tap the
«Clear...» button, a dialog will pop up
prompting you to confirm the reset or cancel
the sequence by tapping the Back button ( ).
On the Home screen, the On/Off status of the equalizer is
indicated by the entry «EQ» on the Channel view button of the
corresponding channel strip, as shown in the graphic opposite.
EQ layer/curve
Apart from the overall frequency response, the following functions
and status indicators are provided:
Header section
EQ [n] -
On/Off
On/Off status of the corresponding EQ.
This field also acts as On/Off switch for the
respective EQ.
Data section
Line by line from left to right:
Band selector Allows the selection of a filter band from the
Filter band bar using the encoder.
Filter band
bar
Displays all filter bands that are in use while
the number of remaining filter bands is
indicated next to the bar on the right.
Band On/Off Switches the selected filter band on or off.
d&b D80 Manual 1.9 en 54