d&b D80 - Manual (Page 41)

9.4. Remote
Selecting the «Remote» tab allows you to assign remote settings for
both Ethernet and CAN remote control.
Selecting the navigation field «IP settings» enters the corresponding
subscreen. In addition the IP mode is displayed at the bottom right
of the field.
9.4.1. IP settings
IP address
IP mask
IP gateway
Selecting either field opens the numerical input
mask and allows you to enter the relevant
data.
Wrong entries can be corrected by tapping
the Erase button ( ) on the bottom right.
Tapping «OK» on the top right confirms the
entry, closes the input mask and switches back
to the Remote screen.
Tapping the Back button ( ) on the top left
cancels any entry and switches back to the
Remote screen keeping the previous entry.
Set gateway
to default
Selecting this button the gateway adress will
be derived from the IP adress and IP mask
settings.
IP mode Selecting the field allows the following settings:
Auto
(DHCP)
When the device is connected
to a network with a DHCP
server present, a matching IP
address will be assigned
automatically.
Manual Allows the manual assignment
of IP settings.
Additional information fields
MAC:
Displays the fixed MAC address of the device.
Conn.: Shows which of the etherCON connectors is
connected (busy).
Status: Provides status information on the network.
d&b D80 Manual 1.9 en 41