CUE uniCUE - Manual (Page 8)

8
Touch Panel Controllers / Physical Description
© CUE, a.s. All Rights Reserved.
Ethernet
Power Supply 24 VDC
2x Serial port RS-232/422/485
4x IR/Serial port
4x General I/O
2x Relay 24 V, NO-C-NC
Power output 5 VDC
Audio line output
Audio line input
IR Capture Sensor, IR Transmitter
Rear Panel
This chapter describes rear panel equipped with all connectors. For more details about connection see
chapter Connecting.
IR Capture Sensor
The built-in IR sensor allows to capture IR codes directly by touch panel. For more details see chapter IR
Capture.
IR Transmitter
IR Transmitter allows to transmit IR codes directly from touch panel. Devices can be controlled directly
without controller.
Audio
Two 3-pin connectors provide unbalanced audio line input and output.
Power Output 5 VDC
This 2-pin provides 5 VDC output.
Factory Default Button
When pressed the factory default function is performed. For factory default values see chapter Factory Default
and System Default. A thin screwdriver is needed for press of this button.
Ethernet
The 10/100 BaseT LAN is a standard network connection using RJ-45 connector. For more details see chapter
Connection.
Power Supply 24 VDC
Powering of uniCUE is provided by 24 VDC. Use only delivered power supply.
Control Ports
Rear panel of uniCUE is equipped with following control ports
▪ 2x Serial port ES-232/422/485
▪ 4x IR/Serial port
▪ 4x General I/O
▪ 2x Relay 24 V, NO-C-NC contacts