CUE uniCUE - Manual (Page 37)

37
Touch Panel Controllers / Admin Web
© CUE, a.s. All Rights Reserved.
E-mail
This page is used for setting parameters of e-mail
parameters and recipients addresses.
The SMTP server must be set. See the Configuration/
SMTP setting.
The sender Name and E-mail are addresses of your
CUEunit. The sender Name and E-mail are used by the
XPL2 commands EmailSend and PresetEmailSend.
The recipient Names and E-mails are addresses of
recipients, where e-mails will be sent using the XPL2
command PresetEmailSend.
Settings
Settings
On this page some display features can be set.
The Backlight Saver will switch off automatically
display backlight. Time in minutes can be set. Time set
to 0 means that Backlight Saver is disabled.
LCD Backlight sets display backlight level.
If Adaptive Brightness is switched to Yes, the light
sensor automatically adjusts display backlight
according ambient light level.
If Motion Sensor is switched to Yes the Motion Sensor
resumes touch panel from Backlight Saver mode
automatically.
On Screen Display
This page serves for setting of On Screen Display
functionality.
Type of activation is defined here as well as mode of
the On Screen Display. In Advanced mode all functions
are available, Basic mode is more safety (for example
network settings can’t be changed).
In addition some settings done by On Screen Display
can be enabled or disabled.
Calibration
Use this page to start calibration and follow
instructions on the touch panel.
For proper calibration use a stylus.